Battery-powered tealights are good alternatives to real tealights, but did you know they also have other uses? On their side, they almost look like a snowman's face! All you need to do is add a few eyes, a mouth and some accessories.
[ Edit ] Step
[ Edit ] Making the Base
- Get a battery-powered tealight. You will find them in art and craft stores as well as in the lighting department of a supermarket. A white tealight would work best, but you can also get a white glitter for a nicer snowman.
- Turn the light so that the flame points away from you. Put the candle on the table first and then turn it until the flame tip points away from you. Most battery-powered headlights have a flame that bends slightly to one side, rather than pointing straight up.  As the flame tilts upwards, the snowman will look more cheerful. ] Draw a simple snowman face with a black permanent marker. Make two dots above the flame for the eyes. Make four to five dots under the flame to make the mouth.  Make sure the tip of the flame is pointing upwards, towards the eyes.
- For a more dimensional look, use black puff paint.
- If you use a glitter tea lighting, draw the face with black puff paint. Normal cursor does not show up.
- Consider coloring the flame with an orange permanent marker. The flame will look yellow-orange when it is turned on, but it will look white when it is off. You can fix this by coloring the flame with an orange permanent marker. 
- Do not use a washable "child" marker. The color will rub.
- Do not use paint or paint pens. They are opaque and the color does not shine through.
- Cut an 11-inch (27.94 cm) long piece of thin thin tape and tie the ends together into a loop.  You can use whatever color you like, but red, white or green are usually associated with winter and Christmas. Choose the thinnest band you can find, about 1/16 to 1/8 inch (0.16 to 0.32 centimeters).
- Hot glue tape on the back of the tea lighting. Place a drop of hot glue on the back of the tea lighting, near the top. Press the knotted part of the tape into the glue and allow it to set.
[ Edit ] Add the accessories
- Cut a 2.3 inch (6.35 cm) long pipe cleaning. You can use whatever color you like, but red or green would work best.
- Hot glue tube to the top of the tea lighting. Draw a line of hot glue around the top edge of the tea lighting, just above the eyes. Quickly push the pipe cleaner into the glue. If you need to, gently curve the pipe cleaner first so you do not risk touching the glue.
- Hot glue two mini pompoms to each end of the pipe cleaner. Choose two pompoms in a contrasting color. Place a drop of hot glue on each end of the pipe cleaner. Quickly press the pumps into the glue. 
- Cut a 4½ inch (11.43 cm) long piece of tape.  Choose a thin band, 0.64 to 1.27 centimeters wide. Use a color that matches your earmuffs.
- If you cannot find a tape, use a strip of blanket instead.
- Cross the ends together to form a loop and secure them with a drop of hot glue. Cross the left end over the right to form a loop, as well as the ribbon with breast cancer awareness. Secure the loop with a drop of hot glue. 
- Glue the scarf to the tea lighting. Place a drop of hot glue on the back of the tea lights, near the bottom. Press the inner part of the loop against the glue so that the crossed part is in front. Make sure the back ends of the strap are facing down. 
- Trim the ends of the tape, if needed. The band should appear towards the bottom of the tea lighting. If it continues to hang down, use a drop of hot glue to hold it in place.
[ Edit ] Tip
- Hot glue a flat safety pin on the back and wear it as a brooch. 
- Hot glue a magnet on the back and use it as a cooling magnet. 
- When gluing something to the back of the tea lights, be careful not to cover the switch or the battery.
- Hot glue can leave behind threads or "whiskers", which can make your work dirty. When done, make sure to pull them off.
- Make a whole family of snowmen and vary the patterns.
[ Edit ] Warnings
- Avoid touching the hot glue gun nozzle.
- Avoid touching the hot glue.
[ Edit ] Things you need
- Battery operation tealight
- Black permanent marker or puff color
- Orange permanent marker (optional)
- 2 mini pumps  1/16 to 1/8 inch (0.16 to 0.32 centimeter) tape
- ¼ to ½ inch (0.64 to 1.27 centimeter) tape
- Hot glue gun and hot glue sticks
[ Edit ] References
- [1945 http://onelittleproject.com/tea-light-snowman-ornaments/2/
- ↑ http: //onelittleproject.com/tea-light-snowman-ornaments/2/ 12719709069] http://onelittleproject.com/tea-light-snowman-ornaments/2/
- ↑ http: // onelittleproject.com/tea-light-snowman-ornaments/2/strong19659071strong↑ http://onelittleproject.com/tea-light-snowman-ornaments/2/
- ↑ http: // onelittleproject. com / tea-light-snowman-ornaments / 2/127197490]] http://onelittleproject.com/tea-light-snowman-ornaments/2/
- [1945 http: //onelittleproject.com / tea-light-snowman-ornaments / 2 / strong19659075vard ↑ http://www.serenestamper.com/2012/12/snowman-tealight-ornaments.html
- ↑ http: // www. serenestamper.com/2012/12/snowman-tealight-ornaments.html