Breaking News
Home / How To / DIY Push-Up Ice: 14 steps

DIY Push-Up Ice: 14 steps

This manual shows you how to create your own printing cone when you have a plastic bottle that cannot be recycled. First I will show you how to make vanilla itself, how to prepare the bottle.

Vanilla ice cream
  • Bottle DIY
  • Accessories:


    • 500 ml milk “/> 125 grams of sugar
    • 100 grams whipped cream
    • 6 egg yolks
    • 1
      vanilla pod
    • (optional) chocolate, candy, sweets
    • ice cubes or cold water

    Equipment: [19659005] figure

  • ice maker
  • whisk
  • spatula
  • bowl
  • knife [19659005] cutting board
  • egg separator
  • Also a plastic bottle and a straw.

  • 19659026] Add tip

  • Step 1:

    Cut the vanilla bean next to and scratch the pulp into a cooking pan. Add the milk and half the sugar. Add tip

    Step 2:

    Separate eggs and mix the 6 egg yolks with the rest of the sugar.

    But don't whip it creamy.

    Bring the vanilla milk again.

    Step 3:

    Slowly mix the milk sugar mix with the egg-yellow sugar mixture in the bowl.

    Fill another cooking pot with water and boil (or clean the first one)

    Step 4:

    Leave the mixture thicken by placing the bowl in the hob (be careful not to overclock) and stir with a spoon. Keep cold whipped cream and a bowl of ice cubes ready.

    When the ice mass has thickened and looks like a rose when you blow over a small amount in your spoon, it is done.

    Step 5:

    Add cold whipped cream and mix.

    Step 7:

    Step 8:

    Image of ” src=”” width=”5472″ height=”3080″/>

    Picture of ” src=”” width=”5472″ height=”3080″/>

    "src =" "width =" 5472 "height =" 3080 [19659072] Put the ice in the ice maker until you have ice cream.

    Put the ice in the freezer until you want to serve it.

    Step 9:

    First you have to cut off the top of the plastic bottle. Then put the straw in the middle vertically and fill the bottom of the bottle with ice cream.

    To make it easier to get the ice out of the bottom of the bottle (we will cut it) I have put some smarties in the first.

    Randomly add more candy to the ice cream in the bottle.

    Until it's full. Add 1917

    Step 10:

    When you want to serve the ice cream, take it out of the freezer and place it on a cutting board.

    Cut the top of the bottle.

    Step 11:

    Take the bottom of the bottle and drill a hole in the middle .

    Big enough to let the straw go through.

    Step 12:

    Put the bottom with holes under the glass in the bottle.

    Step 13:

    Ask a question

    Step 14:

    Bottom protects your hand from molten glass, but not the floor or your pants, be careful.

    All is gone. It really works!


    Backyard Contest “/>

    Source link