Home / How To / Common refrigerator problems and how to solve them

Common refrigerator problems and how to solve them



The refrigerator has become a must, so when it has problems, it justifies a quick response. As with most appliances, refrigerator problems never happen at a convenient time, so knowing what the problem may be will get you on the road to repairing faster.

Running away

Refrigerators have many working mechanisms to keep the temperature and keep the refrigerator and freezer compartment at the perfect temperature. When the unit is working against temperature control, you will hear the unit buzzing, but it should not do so all the time. If your device is loud or constantly running, you probably have a problem with your condenser coils.

You may be able to remedy the situation with a thorough cleaning. Food and dust debris can cover the device and cover its ability to operate efficiently. Turn off the power to the unit by unplugging it and then placing the coils, usually located near the bottom of the unit. Dry or vacuum the coils to clean debris.

Also check the temperature setting for your device. If it is set too low, the motors and fans can only be overloaded. The ideal temperature is at or below 40 degrees Fahrenheit.

Delicious

leaking puddle in the kitchen near the refrigerator

The point of the refrigerator is not just to house food but to contain all the liquids that are involved in the cooling process. When you notice water dripping or pooling, you have a problem – probably with the defrost drain. This drain hose is usually located on the back of the refrigerator, near the bottom. If the hose is blocked by ice, try feeding hot water through the house from the inside of the refrigerator or, even better, defrost the refrigerator, clear lines and slide it up again.

The hose can also be blocked by debris, in which case you can remove, clean and replace it. Also check the water supply hose where there is water in the refrigerator. Check for cracks or tears that can cause drops when handling hoses.

Problems with ice makers and water dispensers

freezer ice tray

One of the most common problems with modern refrigerators is that the water dispenser or ice machine does not go out on request. It is important that you regularly replace the filter inside the refrigerator, which can become clogged. You may also have problems with the supply line being clogged or the water being turned off at the source, usually under the sink.

For the ice maker, make sure that it was not accidentally turned off by either the electronic controls or the metal flap inside the ice tray that manually shuts off ice production. Also look for frozen hoses and ice stops throughout the system. If the engine does not run, there can be many problems, some of which require replacement.

Failure to be cool

If your refrigerator does not maintain the preset temperature, check these condenser coils again and listen to ensure that the evaporator fan is blowing. If the problem does not exist, it may be the condenser fan motor. Another probable culprit is the defrost thermostat. You may also have a problem with the motherboard or motherboard. While all of these are DIY options, the cost of some of these repairs is prohibitive and it is better to invest in a new device.

Rock, Rattle and Roll

If your refrigerator makes a lot of noise, it’s probably one of the fans who runs overtime. Check the condenser fan and evaporator fan as the most likely fault points.

Frosty freezer

freezer with ice trays and frost build-up

Yes, the freezer should create ice, but not all over your packaging and protected foods. First check the freezer setting if your unit burns food in the freezer or results in ice sheets inside the unit. Then perform a freeze. Remove all objects, disconnect the unit, wipe off water and debris inside and check all hoses. You may have a clogged defrost drain that drips water into the freezer, which then freezes into an ice sheet. Check the seals on the freezer door as well as any seals around the ice machine once they have been reassembled. An air leak in any of the locations will cause icing inside the unit.




Source link