Home / How To / 3 ways for DIY substrates

3 ways for DIY substrates



Creating your own wallpaper is an easy way to look up a side table or create a custom gift. Start by collecting all your goods and putting out magazines on a table to act as a barrier between your project and the table. After all, DIY projects can get a little messy.

Tiles

Tiles are as simple as DIY coasters. Go to your local hardware store and look around the tile section. Tiles are available in all shapes and sizes, so be careful when ordering tiles online. You want to make sure your tile square is about four or five inches on each side. Small tiles like this can usually be found by bathroom or backsplash tiles in any hardware store and will usually set back less than a dollar a piece.

Once you have your tile, be sure to clean it with a mild soap and water mixture and allow it to dry completely. When the tray is dry, turn it to the back and use hot glue or E-600 ̵

1; a very strong tile adhesive – to attach four circular felt pads to the bottom. It is extremely important that you use glue that sticks to the rougher, back of the plate. Many felt pillows are self-adhesive. Do not use a self-adhesive pad for this project. The pillows themselves must be small enough so that four of them can fit evenly on the back of the plate – one in each corner.

Let the glue on the pillows dry and then turn them over and you're done.

 homemade yarn tracks

Twine Coasters

Start by taking the cardboard box and cut it in a circle. This circle will ultimately be the size of your coaster so measure twice, cut once. It's a good idea to trace a cup or bowl to get a perfect circle that you can replicate over and over again – especially if you want to create a set of DIY coasters.

When you have your circle, mark in the middle with a pencil. Take a roll of twin and gently glue the end down the middle. Then start wrapping the yarn in a swirl pattern around the original glue point. When wrapping, make sure to glue carefully. Whether you use a strong manufacturing adhesive or hot glue, make sure you can't see the glue on the top or sides of the yarn. Although it is important, less is more here.

Swirl the yarn until you reach the outer edge of the coaster, then cut the yarn and attach the tail to the side. You can add felt pillows to the bottom of this rocker if you like.

 laser-cut patterned rock and tile plates

Patterned substrates

For patterned substrates, you need a ceramic tile, just like those used in the DIY tray. White tiles work best for this project. Once you've got your tile, you'll need to find some patterned craft paper and cut it to the same size as the tile plate. You can trace the underside of the tray on the paper to measure the size.

After cutting the paper, place a very thin layer of mod podge on the plate and attach the pattern to the plate. Allow this layer to dry. When the mod-podge is dry and the paper is safe, mod-podge over the top several times. When you create your mod podge, you create a protective barrier over your pattern. When the mod podge is dry, add felt pads to the back.

If you are a fan of photography-related crafts you can use an image as your pattern.

The Wrap

When your project is complete, you can take a bundle of four or six and wrap them as a gift. You can create your own wrapping paper or simply tie the bundle with a beautiful ribbon or string. You can't go wrong, as long as your coasters are nice and dry.


Source link